Taparia Locking Plier - 175MM - 1641-7

• Manufacturer: Taparia Tools Ltd.
• Model: 1641-7
• Product: Locking Plier — 175 mm
• Length: 175 mm (7 inch)
• Type: Locking plier / vice grip
• Action: Clamps and locks onto the work, then releases with a lever
• Adjustment: Screw at the handle end sets the jaw opening

Taparia Locking Plier 1641-7 is a 175 mm vice grip — it clamps onto the work and stays clamped with no hand pressure, then releases with a lever.

That is a genuinely different capability from an ordinary plier, not just a convenience. Because the tool holds itself on, it becomes a third hand: a temporary clamp, a handle welded onto nothing, a way to hold two parts in alignment while you fix them. It will also grip a rounded-off nut or a sheared bolt that no spanner can touch, which is often the only way such a fastener comes out.

Setting it correctly is the whole technique. The screw at the handle end sets the jaw opening, and you want it adjusted so the handles close with real effort — a firm snap. Too loose and it slips under load; too tight and it will not close at all, or it damages the work.

Technical Specifications

1) What makes a locking plier different from ordinary pliers?

It clamps on and stays clamped with no hand pressure. That turns it into a third hand — a temporary clamp, or a way to hold parts in alignment while you fix them — which an ordinary plier cannot do.

2) Will it grip a rounded-off nut?

Yes, and that is one of its best uses. A locking plier bites into what is left of the flats and holds hard enough to turn a fastener no spanner can grip. It is often the only way a sheared or rounded bolt comes out.

3) How do I set the jaw opening?

Use the screw at the handle end, and set it on the actual work rather than guessing. Adjust until the handles close with a firm snap — real effort, but they do close. Too loose slips; too tight will not close at all.

4) Will it damage what I clamp it to?

It can. The serrated jaws bite in, which is how it grips. Use packing on finished surfaces, or accept the marks on a fastener you are removing anyway.

5) Should I use it instead of a spanner?

No — on a sound nut, use a spanner. A locking plier grips on two faces and will damage good fastener flats. Save it for fasteners that are already rounded or sheared, where nothing else will work.

1. Return within 24 hours of delivery for:
   • Damaged or defective product
   • Wrong or missing item
2. Product cannot be returned once installed or used
3. Refer to Refund Policy for complete details